Verified hardware compatibility guide and parts catalog. Upgrading your Xbox Wireless Controller (Series X|S) with hall effect joysticks on the Model 1708 (Xbox One S Bluetooth) motherboard architecture.
Previous-generation Xbox One S controller with Micro-USB port and integrated faceplate. Model '1708' is labeled inside the battery compartment.
Internal ribbon pinouts and trigger brackets change with each revision. Select your board version below or plug in via USB for instant hardware detection.
Standard Series X|S controller with USB-C port. Check the model number '1914' printed inside the battery compartment beneath the AA batteries.
Previous-generation Xbox One S controller with Micro-USB port and integrated faceplate. Model '1708' is labeled inside the battery compartment.
Electromagnetic replacement joysticks that use contactless magnetic sensors. Immune to mechanical potentiometer carbon wear and stick drift.
Yes. Every part featured on this page has been verified to match the specific circuit traces, ribbon cable pitch, and internal housing brackets of the Model 1708 (Xbox One S Bluetooth) revision.
Previous-generation Xbox One S controller with Micro-USB port and integrated faceplate. Model '1708' is labeled inside the battery compartment. You can also connect your controller via USB to run the WebHID auto-detector above.
Most kits require a PH00 Phillips screwdriver, plastic prying pry tools, and tweezers. If installing Hall Effect joysticks, a soldering iron, desoldering pump/wick, and solder flux are also required.